Share this content on Facebook!
08 Oct 2018
In the daily production and operation of our Pet Bottle Mould, we must do a good job in the maintenance of equipment and molds, so as to extend the life of their use, but also bring you better use efficiency.
1 Look at the body of three people may also leak, may be blocked, the cup of the water tank is too full.
2If the electromagnetic valve of the plastic blow molding machine is abnormal, it should be cleaned in time.
3 Plastic blow molding machine molds must be cleaned and polished regularly.
4 Open the source under the pressure switch must be slow to prevent the air flow from blowing dust into the solenoid valve too quickly, and open the exhaust valve for 30 seconds to ensure the air is clean.
5 Plastic blow molding machines must ensure that the mechanical parts are good, there is no one inside the machine, no foreign objects. Especially the handle position to avoid injury. Also close the security door.
Polyester blow molding machine
Polyester blow molding machine
6 Start the machine must start the motor, delay the heating machine for 30 seconds to prevent voltage jitter. Before starting heating, you must ensure that the cooling water is not turned on.
15 minutes after the start of heating (2 - 3 minutes), when the oven temperature rises evenly, press the button in the embryo. At the same time, open the bottle's power, or do not blow the bottle.
7 Plastic blow molding machines must pay close attention to whether the machine will run with the same noise to achieve early detection and stop early settlement in time.
8 In an emergency, press the emergency stop button and press the brake. Then find a quick solution to the problem based on an analysis of the cause of the site.
9 After normal operation, the body of any part of the machine should not be placed in the machine, so the robot will not hurt people. If the machine has an abnormal sound, you can slow down after watching.
10 After normal consumption, the operator should always observe the quality of the bottle to avoid shaking voltage or other reasons that affect the quality of the bottle.
11 During maintenance, press the service button to ensure the safety of the repair according to the defects on the touch screen. If you need to observe the movement of each mode by hand, please pay attention to the position of the robot. At the same time, it is important to understand the role of the button separately and then put it into action. Make sure the error is caused by unnecessary trouble.
12 After each repair, you must ensure that tools and screws are cleaned to prevent the machine from remaining and affecting the normal operation of the machine.
Jilian Plastic Mould is a professional pet preform design and manufacturer. We have pet preform products and equipment of various capacities. No matter what your pet preform needs, we can satisfy you. Our new 5-gallon Pet Preform are even larger and able to meet the diverse needs of our customers.


Comments

There isn't any comment in this page yet!

Do you want to be the first commenter?


New Comment

Full Name:
E-Mail Address:
Your website (if exists):
Your Comment:
Security code: